Eyelet setting tool for eyelet size 00 (hammer type)

Hammer type, eyelet setter for #00 eyelets and washers. This setter functions differently than the hammer type grommet setter; it has no base. The eyelet is placed on the table/floor the fabric is placed over it (centering the hole of the fabric on the hole of the eyelet) then add the washer and balance the setting tool in the holes which are lined up. Use a rubber mallet and strike the end of the setting tool. NOTE: washers must be used with the eyelets or they do not set properly as the shank is too long and the fit will be loose. Always test set a few on scraps.